britax 511 switches Switch Panel Flat Bezel – Burton-Racing

britax 511 switches Switch Panel Flat Bezel – Burton-RacingPLEASE Select switch LED color using the drop down box. Our switch panel is the best of the best for analog chassis control. We only use the highest quality name brand components such as genuine Carling Technologies switches, covers, and seals with IP dust and water resistance ratings all assembled right here at our facility for a premium fit and finish. This switch panel uses a universal bezel for flat panel mounting in a wide variety of

PLEASE Select switch LED color using the drop down box.

Our switch panel is the best of the best for analog chassis control. We only use the highest quality name brand components such as genuine Carling Technologies switches, covers, and seals with IP dust and water resistance ratings all assembled right here at our facility for a premium fit and finish.

This switch panel uses a universal bezel for flat panel mounting in a wide variety of applications. If you need a radio style bezel please CLICK HERE.

Included are (6) six pre-wired (2) two position ON-OFF toggle switches with one of them being a momentary starter switch located in red. We use real Carling plugs so swapping out a switch or rewiring a panel for a custom application is a breeze! No confusing and ugly hard to work with spade connectors, our solution is tidy and compact!

Our panel is SIMPLE, 6 switches with straight forward uses:

Your switch on the far left is your main on/off power into the panel with 2 LED indicators. The bottom light shows you have power to the panel letting you know the vehicle's ignition or battery cutoff is in the on position helping you to stay alert and not kill your battery. This also provides easy diagnostics by knowing you have power to the panel before digging into your electrical system for troubleshooting.

The solid red switch is a momentary starter signal output. This means it toggles and bounces back if you are not holding it down (it will not stay latched, just like turning your key to start a vehicle). This switch is to be used to start the vehicle only and is showcased in a bright red finish so you do not accidentally use the switch with the engine running. This also help separate your main power switch on the left to be an easy isolated kill switch in emergency situations. PLEASE NOTE: If your starter solenoid requires more then a 10 amp draw or you are cranking the vehicle for extended amounts of time you may need to wire a relay in between the switch and the starter itself to isolate high amperage spikes. Failure to do so may damage the switch.

The 4 remaining switches are outputs used to send power to relays, lights, or other devices with an 8 amp limit for each channel (maximum combined 20 amp peak). No confusing low side high side talk, you hit the switch and it sends voltage to your component. This makes it easy so you can ground the component at its location, no doubling up on wire runs front to back of the vehicle. All 4 of these switches are armed by the main ignition switch on the far left, this means in an emergency you can kill power to all 4 switches with the flip of only 1 switch. A single LED indicator is at the top of each switch showing when a switch is in the on position for an easy visual of what channels are currently activated.

This switch panel features a 12" long harness with 8 pin DTM Male connector, you can purchase the mating connector if you CLICK HERE. If you would like to use our mating harness that provides ignition, starter, and ground hook ups with a 3ft extension for the 4 output switches you can CLICK HERE.

Pinout: