anthurium transfer Anthurium (61 x 89cm)

anthurium transfer Anthurium (61 x 89cm)Applying Redesign Dco Transfers is truly child's play. We'll explain how it works below. STEP 1Prepare the surface where you want to apply the transfer. Sand it smooth with some sandpaper if necessary, and ensure the surface is free of dust and grease. STEP 2 Determine exactly where you want the transfer and cut out any necessary sections. Don't remove the protective film yet, and be careful not to get any unwanted parts of the transfer stuck to

Applying Redesign Déco Transfers is truly child's play. We'll explain how it works below.

STEP 1

Prepare the surface where you want to apply the transfer. Sand it smooth with some sandpaper if necessary, and ensure the surface is free of dust and grease.

STEP 2

Determine exactly where you want the transfer and cut out any necessary sections. Don't remove the protective film yet, and be careful not to get any unwanted parts of the transfer stuck to unwanted areas. This will make it difficult—almost impossible—to remove.
Especially when you cut out pieces of transfer paper and want to stick them next to and on top of each other, it's helpful to tape the cut-out pieces, with the protective film still attached, to your furniture with some masking tape. This way, you get a good overview of your design and can continue to build your "puzzle."
You can layer multiple pieces of transfer material on top of each other. Where the designs overlap, the bottom design will no longer be visible. Partially overlapping the pieces creates more depth in the design.

STEP 3

Once you're happy with where you want each piece or the entire transfer to be, remove the pieces with the masking tape. Remove the protective film one by one and then apply the transfer, adhesive side down, to the desired locations. Try to do this as evenly and smoothly as possible to avoid creating bubbles.

STEP 4

With the supplied stick (or Using the transfer tool , rub the transfer onto the furniture. Place the stick, with the long side facing upward, at an angle of about 45 degrees to the back of the transfer. By rubbing and applying pressure, the image will gradually transfer from the film to the furniture. The principle is similar to that of a temporary tattoo.

It's easiest to work slowly from left to right, or vice versa. Each time you complete a section, gently pull the backing film upward to check if the design has been transferred properly. If not, replace the film over the design and continue rubbing with the stick. Gradually work your way to the right until the image is completely transferred.

And you're done...!